Waterlox Original Sealer/Finish Quart

Description

Product Details:

• Applies easily with a lambswool applicator (floors), China bristle brush, cloth or spray. Sanding is not necessary between coats for adhesion purposes.
• Waterlox Original Sealer/Finish is desigend as the sealer/primer and top coat portion of our finishing system which performs best over bare wood
• Apply all intended coats to a small, inconspicuous area or a scrap piece of wood from the project and allow to dry prior to applying to the entire surface
• Final color effect is always influenced by the grain, texture, porosity, species of wood, and by method of application
• Non-Toxic when dry

Product Uses:

• Use on interior wood surfaces including floors, windows, doors, cabinetry, woodwork, tables, furniture, bar tops, picture frames, fly fishing rods, gun stocks, and various woodworking projects
• Coverage: For hardwood species we recommend 3 coats of Waterlox Original Sealer/Finish. For softwood species such as pine, fir or cherry, apply 4 coats of the Waterlox Original Sealer/Finish.
• For best results, apply all coats liberally at approximately 500 square feet per gallon per coat. No thinning necessary.
• Clean application tools immediately with mineral spirits or turpentine
• Exceptional adhesion to oily, dense, exotic woods like teak, rosewood (other than Cocobolo), and Ipe
• Use on porous interior surfaces such as slate, brick, stone, tile, linoleum or cement to seal and prevent chalking and dusting*.
• For exterior projects as a sealer only, use 1-2 coats to prime, followed by 2 coats of Marine Finish
• Same product as Waterlox Original Marine Sealer
• VOC 614 g/L
• Special Winter Storage Information: Cold temperatures will not negatively affect Waterlox®, but if it has been chilled or exposed to freezing temperatures, allow it to stand for at least 6 hours in temperatures above 60° F before using. DO NOT artificially heat Waterlox® products.

*Apply all intended coats to a small, inconspicuous area or a scrap piece of wood from the project and allow to dry prior to applying to the entire surface. Final color effect is always influenced by the grain, texture, porosity, species of wood, and by method of application.

Download SDS Sheet